PlateCool Frame – Cooling Frame for Print Plates

PlateCool Frame – Cooling Frame for Build Plates Print finished? Plate out, onto the PlateCool Frame – let it cool down, PEI stays happy. 😄   "This design became possible after I involuntarily 'converted' a textured PEI into a smooth plate." 😅   You know it: print is finished, part looks good... and then the voice in your head whispers: "Pull it off. Now. Immediately." And bam – scraper action, scratch drama, PEI offended. 😅   The PlateCool Frame is your parking spot for hot build plates: plate out, place it on, let it cool down in peace – while the next plate is already working overtime in the printer.   Why you want this: Many parts detach almost by themselves after cooling down (magic of physics ✨) Less "force" = longer lifespan for your coating Ventilated sides help with cooling 5 rubber buffers underneath: non-slip & table-friendly 4 holes for hanging: because workshop walls always have too few holders anyway 😄   ⚠️ Important: Plates can be very hot – so please be careful when removing and use PETG or higher for the frame. Fingers are "multi-material", but difficult to calibrate.     If the PlateCool Frame saves you from scratches, scrapers, and curses: a Like, Comment, or Make from you would be awesome. 😉   Print Settings Layer height: 0.2 mm Walls: 2 (3 for the "Overkill League") Infill: 15% Support: not needed Material: PETG or higher recommended Filament required: approx. 52 g Optional: Brim, if your filament has a "warp day" today