Playdate magnetic charging stand

A magnetic charging stand for the Playdate. It uses eight round 8mm x 1.5mm (or four 8mm x 3mm) neodymium magnets for the corners (two for each) and four rectangular 5.75mm x 19mm x 1.75mm for the center. The magnets are connected to a standard 5v USB 2.0 charging cable (red goes to the top magnet and black goes to the bottom magnet). Then use the provided cable caps (cylinders) to firmly press the cables onto their place. To complete the setup, wrap the USB cable around the center “roundabout” piece and guide it through the bottom opening. Finally close the stand by pressing the back cover onto it (snap-on). The stand can be printed without supports but you need to add stops at layer 10 (to add the center magnets) and 16 (to add the corner magnets). Otherwise add supports for the corner and center holes. The base of the stand is hollow so that you can add a stop at layer 190 to add pennies/sand/gravel to add weight to the stand.Apart from the Playdate console, it can also be used for: