Playstation 5 Controller Mini Wheel

What you will need - Not everything is printable - Please read the instructions! 608 bearing, 22mm diameter, 7mm thick, 8mm center. Skateboard bearing 1.6mm diameter metal rod X2 [butterfly paper clip/14 gauge finishing nail/wire] I used a m2x20 Superglue Made a few changes to original rack by making the gap smaller so when it's sliding back and forth it has less give. There's 2 versions along with the original rack so you can pick which tolerance works best for you. Also made the nub bigger so that it sits in the square hole better. Need to work on the home button some more, plan to put in a spring so it works nicer. Post-Printing Break off the support piece Attach the pivot to the rack: Method 1: Screw m2x20 into the top of the rack and it will sit freely in the pivot. Method 2: Cut down a 14 gauge finishing nail to a length of 20 mm. Pass the nail up through the pivot and into the rack. The pivot should spin free on the nail with minimal play. Put a drop of superglue in the slotted