PlayStation 5 Power Button Cover - Simple

I was having an issue where my cat would sometimes turn off my PlayStation 5 by pressing the power button on the front. I wanted to stop this from happening so I made this simple little cover that will slide over the front of the power button and is shaped to fit snug and not fall off when touched. It can be slid to the left and right slightly if you want the placement to be a little different.

I made this design from scratch on Tinkercard after searching multiple sites where no one had a cover for the ps5 power button available.

I have an Ender 3 with:
*Glass Plate
*Liquid Glue for better adhesion
*Creality 3D Printer Silicone Solid Bed Mounts (instead of the springs)
*A Creality Heat cover tent (because cats & stuff)
*Use Ultimaker Cura 5.0.0 for slicing

Print Settings:
Layer height: 0.2 mm
Initial Layer Height: 0.2 mm
Brim for better adhesion
Brim Only on Outside (CHECKED)
Infill: 70% - This can likely be reduced, I'm still a beginner and it was already set to 70