Thingiverse
plexiglass holder clips for 3D printer enclosures
von handell
154
Downloads
87
Likes
0
Makes
plexiglass holder clips
3D printer enclosure plexiglass holder clips
contact at [email protected]
these will work well on 2.5 or .08" thick plexiglass
corner clips 2-3 per corner
side extender clips - 2-2 per side
hinges - print twice to create one hinge - use 3mm bolts or create a pin from a thin nail
- print hinge with brim
angle clip if needed
can be use a temporary holds or glue in for permanent enclosures
any gaps can be tapped off with strong tape
3D printer enclosure plexiglass holder clips
contact at [email protected]
these will work well on 2.5 or .08" thick plexiglass
corner clips 2-3 per corner
side extender clips - 2-2 per side
hinges - print twice to create one hinge - use 3mm bolts or create a pin from a thin nail
- print hinge with brim
angle clip if needed
can be use a temporary holds or glue in for permanent enclosures
any gaps can be tapped off with strong tape
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
