Plier Rack for Tool Chest

I wanted to tidy up the contents of my tool chest, particularly the pliers, channel locks and cutters. I had seen a commercially available product that stores pliers, etc edge up to make better use of the drawer volume and decided to make my own version.

It's a simple design, but we've all got to start somewhere.

If i decide to tweak the design at some point i will likely increase the thickness of the dividers by 1mm for added strength and increase the width of the smallest slots by 1mm.

The tongue and groove type connect between the two parts is because my printer bed isn't wide enough to accommodate the full width of the design. I had to take a small file to the tongue to get a decent fit. The two parts are glued together with cyanoacrylate.