Thingiverse
Plug in a plug (Type M)
von scholtzap
4
Downloads
4
Likes
0
Makes
I made this design because in my kitchen I have one more appliance than I have plug in space. So, I decided to modify a normal (Type M) 3-prong-plug that I had lying around to allow another appliance to plug into (on top) of it. Theoretically you could endlessly stack these onto each other, and I don't know why this isn't a thing yet...
More likely than not, you won't be able to use exactly the same design as I have here - because plugs come in all different shapes and sizes, but at least there is something to work off of.
NOTE: The only thing I had to print was the "cover.stl". The remaining parts were all already part of the plug that I modified. I suggest you buy a similar plug and work around the shape it has. For the terminals on the inside I used parts from a old multi-plug I had lying around and a 9mm bullet casing for the earth pin... which i cut a slot into so it would part when pushing the top most plug into it.
Initially I wanted to make the plug as safe as can be,
More likely than not, you won't be able to use exactly the same design as I have here - because plugs come in all different shapes and sizes, but at least there is something to work off of.
NOTE: The only thing I had to print was the "cover.stl". The remaining parts were all already part of the plug that I modified. I suggest you buy a similar plug and work around the shape it has. For the terminals on the inside I used parts from a old multi-plug I had lying around and a 9mm bullet casing for the earth pin... which i cut a slot into so it would part when pushing the top most plug into it.
Initially I wanted to make the plug as safe as can be,
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
