Plug-in case for your project - DIY BOX

Plug-in case for your project - DIY 1 to 4 compartments for your small items. For example, pencils, staples, rubber bands, wago clamps, screws, nuts, fasteners, tools, small office supplies, workshop supplies, school supplies, etc... The lid fits into the base very tightly, remove the protrusions after printing.Maybe the first layer of printing will be loose at the overhang, remove this layer, it does not affect the strength.I printed without supports. I tried both PLA and PETG and both results were very good. The lid has a stop to prevent accidental removal.As you slide the lid off, lift the edge slightly with your fingernail and slide it to the side. 1 plate - lid + base with one compartment. Internal dimensions 186x54x26mm2 plate - lid + base with two compartments. Internal dimension 2x 91x54x263 plate - lid + base with three compartments. Internal dimensions approx. 3x 60x54x264 plate - lid + base with four compartments. Internal dimensions approx. 4x 43x54x26 The second print prof