Slicer Discord
Pluto A 2,5 Inch 3D-Printed Speaker Driver – 3D-printbaar model van MakerWorld MakerWorld
Gadgets

Pluto A 2,5 Inch 3D-Printed Speaker Driver

door Hexer3D · Gadgets
24 Downloads
11 Likes
4 Makes
Model downloaden
This is Pluto:The speaker features a foam surround for enhanced efficiency and a large neodymium motor. However, the motor has its drawbacks, as it allows for excessive excursion and isn't very efficient. I designed this driver purely for fun. Things you need: 5x20mm Neodymium magnets, and one big 20x20mm Neo magnet.2,5 Inch foam surround type e Assembly: Use 0.15mm enameled copper wire for optimal performance. Before you begin, apply some glue to the voice coil structure. Start winding the wire, gluing it at intervals to ensure a secure bond. Once you've finished winding, apply glue generously around the entire coil to firmly secure it to the structure. For gluing the spider to the chassis, as well as securing the coil to the cone and dust cap, use a two-component adhesive. To attach the surround to the chassis, use a rubber-based glue for a secure bond. I wont update this design. Disclaimer: The measurements taken are near-field and do not reflect the efficiency of the speake
Categorie
Gadgets
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Waarom?
uitgebreide nabewerking
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 2/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Min. bedgrootte
20 mm (Klein)
Nabewerking
Lijmen, Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

Hexer3D publiceert ook op

8 extra modellen op 1 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie