πMiga - Raspberry Pi 4 case

A case for a Raspberry Pi 4 + SSD drive inspired by the classic Amiga 4000 look. To get the led and the switch working in Raspbian, you need to change /boot/config.txt adding the following lines: # HD led dtoverlay=gpio-led,gpio=8,label=hdled,trigger=mmc1 # power indicator gpio=4=op,dh # start a system shutdown when the button is pressed dtoverlay=gpio-shutdown Connect the LEDs and the switch to the above mentioned GPIO pins. BoM: 5 M3 screws (4 for the SSD, one to block the top part of the case) 4 M2.5 screws for the Pi (unless you prefer to use my “pi blocker”) 4 6x3 magnets for the front plate 1 green 5mm LED 1 yellow 5mm LED 2 330Ω resistors 1 6x6mm tactile switch some wires