Pocketbook Verse/Verse Pro e-reader holder

Holder for Pocketbook Verse and Verse Pro modelsI found that when holding the e-reader (especially lying on my side) was quite uncomfortable to hold and kept slipping away. So I designed a simple holder that is comfortable in the hand and would still allow me to use the buttons. Have used for a while now and so far it holds up well in PLA. The buttons are far better to use with the holder.PrintingMaterial: PLALayer height: 0.2 mmInfill: 15% gyroidSupports: Tree supports only on build plate are required for the “hooks” that hold the device.Additional modifiers: 100% infill for the hooksAll of these settings are in the provided print profileInstallingGently slide the Pocketbook behind the hooks.NotesThe weakest part of the design are the “hooks” because of layer separation so I tried to mitigate it with fillets. I printed with PLA and have been using it for a while - so far it has held up perfectly. Although there isn't a lot of stress on the hooks, you could print it in PETG for it