PoGo Gift

My imagining of Pokemon Go Gift as a keychain. Model requires 0.2 nozzle due to very small detail. You can of course scale it up and it should print nicely on 0.4, but keep in mind tolerances might go out of whack. This model comes in quite a few parts because I am not fan of multicolour multi-day-long and ton-of-a-waste-poop prints and I prefer print in parts and then put together with glue.I have used CA glue (the same your good old regular super glue) to connect parts - after day of drying it keeps everything solid. I have also attached 2 extra pieces in raw files:Extra ribbon - this is a 4-part ribbon that is easier to print in good quality due to more optimized orientation, but is weaker, requires more putting together and gluing.Extra panel - I tried experimenting with glow in the dark lights, it somewhat worked but was nightmare - i just printed a flatish panel geometry and slid it between the parts. If you want to try I have added file I have used. Since it was glow in the dark