Poi Ball Handle

The handle on my poi balls broke, so I used this jump rope handle to design a new one. I created a hole for the bearing to fit into. I made it big enough to hold the flashing light section from the original handle and added a lip to hold it. I still need to use tape to keep it shut, though, so it isn't perfect. The bearing used is 12mm in diameter.

Please note: the flashing lid and the bearings were salvaged from my old poi ball handle.

Print settings on Bambu Printer:
Brim: Inner and outer brim 10mm
Layer height: 0.12mm Fine
Infill Patern: Gyroid 15%
Printed on Silent Mode (50%)
No supports