Poke Ball

My young son, who of course is into Pokémon, wanted to create a poke ball. One that could be held together with magnets. So this is what we came up with. The top is held on with 4 magnets (two on top, two on the bottom.) The two half's of the ball should be printed with the opening down, supports on, unless your printer can handle that dome without support. I also printed the middle strip half's with support as well, to ensure the hole for the magnet didn't droop and not leave enough room for the magnet. You'll need 6mm x 3mm round magnets. (Link to the ones I used below). Also, this model does require some gluing, so you'll want an appropriate glue for your filament. I also used a tad of hot glue, as you'll see in the instructions, but you may be able to use the superglue here as well.

Print all 5 parts. Insert 2 of the magnets into the receptacles in the middle band, then glue to two half's of the middle band together. The other 2 magnets go into the receptacles on