Thingiverse
Pokeball Mimic
von deinfinityx
20
Downloads
21
Likes
0
Makes
This is my Mimic Pokeball.
I printed the top and bottom in 0.3mm layer height with 10% infill.
The mouth pieces, eye and slot I printed at 0.2mm layer height infill doesn't matter. I had bad stringing issues with the teeth. Personally I think it add to it but I would also like to make one that does not have that issue.
I also included the full mimic pokeball for anyone who wants to try to resin print it.
I will likely continue working on this.
I printed the top and bottom in 0.3mm layer height with 10% infill.
The mouth pieces, eye and slot I printed at 0.2mm layer height infill doesn't matter. I had bad stringing issues with the teeth. Personally I think it add to it but I would also like to make one that does not have that issue.
I also included the full mimic pokeball for anyone who wants to try to resin print it.
I will likely continue working on this.
deinfinityx veröffentlicht auch auf
103 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
