Thingiverse
Pokeball
door Gdudud
13
Downloads
31
Likes
0
Makes
This is a pokeball designed to have a push button to open. The ball prints in 3 parts: top, bottom, and button. Split the STL file into parts in the slicer program to separate. Multimaterial was used for the top and bottom sections of the ball.
A piece of wire was used as an axle for the hinge.
Prints were done at 20% infill in PLA. Use supports for both the top and bottom sections of the ball.
A piece of wire was used as an axle for the hinge.
Prints were done at 20% infill in PLA. Use supports for both the top and bottom sections of the ball.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
