Pokémon Clone Chamber

Pokémon cloning chamber for figure storage, still a work in progress.
The base is the top and bottom, you will need to print 2, the clearance of parts should allow you to snap this together, additional components, detail and structural support changes might need to be made later.

**edit 1 - 21/9/23** Made a minor adjustment to the clearance of the stand/top, fitment was a little too tight, widen the spacing from .2MM to .5MM (New part is PMC 2)

**edit 2 - 26/9/23** Added new modified separate top and bottom sections along with a slightly changed center column adjusted for future stand attachments
New parts are PMC_Top, PMC_Bottom, PMC_Center, leaving the originals in case someone prefers them or wants to use it as a remix

**edit 3 - 28/9/23** Added some photos of the completed parts, the surface areas need some work as the supports them them rougher than I would like so I may make some additional changes to the design for a no-support needed version