Pokemon Pikachu Hueforge

Do NOT adjust the thickness (Z) in your slicer!! The layers will not come out right. You CAN adjust the other dimensions (X,Y) though to make it bigger or smaller, just not the thickness. These were my settings and colors for my print that you see in the picture. Your results may vary depending on the filament you use. Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm I used Elegoo PLA. I included some of my frames too. The .3mf countains variable layers and a Pause for the Black to White swap if you only have one AMS. Swap Instructions: Start with Black At layer #10 (0.88mm) swap to Red At layer #15 (1.28mm) swap to Orange At layer #19 (1.6mm) swap to Yellow At layer #25 (2.08mm) swap to White for the rest.