Pokeyball Egg Stencil

Happy easter! Gotta hatch'em all (sorry, couldn't pass up a dad joke like that) This 2 part stencil prints in about 30 mins. For the center line/circle stencil I have set it to use supports on the build plate only, to make it less of a hassle removing lots of small inner supports. That being said, you will most likely need some model snips/exacto knife and possible a small nail file to clean up any of the inner channels of the stencil. These were designed to fit standard large eggs, and there is a gap in back of the ring to allow for variance in sizes. If you're eggs are smaller or larger, you can rescale it in your slicer. I wouldn't recommend adjusting the z scale too much if you're scaling down, I think it would make the inner line/circle stencil too small. I recommend using the smaller ring stencil first to paint the red on, followed by the black line stencil once it has dried. I hope you all enjoy this, and as always, thanks for checking out my design!