Polar Scope for Celestron Wedge

You will need ...

Celestron Item #: 94224
https://www.celestron.com/products/cg-5-avx-cgem-polar-finderscope

3 3/8" 16 tpi nuts.
https://www.homedepot.com/p/Hillman-Stainless-Hex-Nut-3-8-16-2532/204786068

This item uses PLA and TPU.

End Caps and Lock are made from TPU and fit tightly to hold scope into polar mount and allow it to rotate but not fall out. End caps snap over ends to keep dust and dirt out of your optics. If you are unable to print TPU you can print the washer part and use a rubber band to hold the scope in place with the washer, but you will loose the protection that the end caps offer.

The main body is printed out of PLA. The opening that the polar scope goes into is tight and WILL need to be lightly sanded in order for scope to be inserted. YOU DON"T want the polar scope to be sloppy. If it is you may need to slightly scale print to ensure that the polar scope fits snugly.

Three nuts are inserted into print so that your wedge's mounting bolt