Thingiverse
Pole Mount for iPhone MagSafe
von iQK
12
Downloads
8
Likes
0
Makes
This is a pole mount for the iPhone MagSafe charger.
designed for an 18mm ID Tube. I used an 18mm ID / 22mm OD as shown in the photos.
!!!!this was designed to be a very tight press fit for the charger into the mount. please ensure it will fit using your print settings and material. keep in mind different filaments shrink differently, and not every printer is calibrated the same.
If you enjoy this design, enable me to make more great designs and consider tipping!
designed for an 18mm ID Tube. I used an 18mm ID / 22mm OD as shown in the photos.
!!!!this was designed to be a very tight press fit for the charger into the mount. please ensure it will fit using your print settings and material. keep in mind different filaments shrink differently, and not every printer is calibrated the same.
If you enjoy this design, enable me to make more great designs and consider tipping!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
