Thingiverse
Poly Dino Key Chain Figure
por Seventh_crow
8
Descargas
3
Likes
0
Makes
I created this little dinosaur in the software SketchUp to see what the limits are.
I provide the file with and wihout a loop so you can decide if you want to use it as a keychain or a figurine.
The smallest I printed this was with a hight of 45mm and layer hight of 0.2mm
I then had an issue with the one arm not being printed correctly. The first few layers of the little arm didn't stick correctly to the supports and came loose. But otherwise it worked out fine. The loop is still big enough to put a chain through.
This is a Work-In-Progress:
In the future I plan to optimize the supports needed and the problem with the arms.
I provide the file with and wihout a loop so you can decide if you want to use it as a keychain or a figurine.
The smallest I printed this was with a hight of 45mm and layer hight of 0.2mm
I then had an issue with the one arm not being printed correctly. The first few layers of the little arm didn't stick correctly to the supports and came loose. But otherwise it worked out fine. The loop is still big enough to put a chain through.
This is a Work-In-Progress:
In the future I plan to optimize the supports needed and the problem with the arms.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
