Thingiverse
Pool Noodle FPV Racing Gate
von dansleeth
18
Downloads
12
Likes
1
Makes
An anchor / base for pool noodles with a 65mm diameter. Ideal for FPV racing gates.
There is a short version (70mm) and a tall version (100mm). The tall version has a bit on the side to allow you to stick a 1cm pole in for support. The tall version also has a small area on the base to thread a cord through (to join to another base and make the noodle bend).
I have also included a tube you could use to join two 65mm noodles together.
All peg holes are 6mm.
There is a short version (70mm) and a tall version (100mm). The tall version has a bit on the side to allow you to stick a 1cm pole in for support. The tall version also has a small area on the base to thread a cord through (to join to another base and make the noodle bend).
I have also included a tube you could use to join two 65mm noodles together.
All peg holes are 6mm.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
