Slicer Discord
pop socket holder – 3D-Druckmodell von Thingiverse Thingiverse

pop socket holder

von Nick45acp
1 Downloads
0 Likes
0 Makes
Zum Modell
This is my first upload and I absolutely do NOT know what I'm doing yet. Alteration requests will send me into a small panic attack and comment will be left on read... This pop socket holder design is very human and provides a solution for an easy, in/out extraction. I figure its been a long time since I've gotten air born in a truck so "locking" the phone in seams stupid now that there's no dirt for me to even drive on. This thing is just barely bigger that the pop socket so there's really no slop to it. I just needed something to hold the phone so I can swipe for the next youtube short (audio only guys). Its really not for viewing your phone while driving. As my wife always says, "if your on your phone you'll kill someone and go to jail for the rest of your life".

Installation procedure:
1. cut a piece of double sided tape and figure it out.
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
ABS
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen