Thingiverse
Popsicle Stick Connectors
di 3d-printy
399
Download
273
Likes
1
Makes
This is a remix of the **PopSticks** toy by Irv Shapiro.
This alternate design cuts a few corners - hopefully in a good way! Both the connectors and the extenders can be printed without supports (in the orientation shown above), but a brim may be needed unless you have *very* good bed adhesion.
"tight" variants have also been added, but the regular versions are recommended.
https://youtu.be/TddTyZ7HkIQ
https://youtu.be/TddTyZ7HkIQ
This alternate design cuts a few corners - hopefully in a good way! Both the connectors and the extenders can be printed without supports (in the orientation shown above), but a brim may be needed unless you have *very* good bed adhesion.
"tight" variants have also been added, but the regular versions are recommended.
https://youtu.be/TddTyZ7HkIQ
https://youtu.be/TddTyZ7HkIQ
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
