Thingiverse
PopSocket back plate
por flying_marvin
2
Descargas
3
Likes
0
Makes
This is a replacement for PopSocket back plates. I came up with the design because those little pins which usually hold the plate in place broke of.
**Print instructions**
You have to use supports to print this. I recommend printing it with the outer side laying on the printbed so you only have to use a few supports for the small “pins”. Therefore, if you do it like this, the supports need to be printed on the part itself, so removing them can be a bit tricky.
I designed the tolerances to fit well with my printer at a layer height of 0.2mm.
**Print instructions**
You have to use supports to print this. I recommend printing it with the outer side laying on the printbed so you only have to use a few supports for the small “pins”. Therefore, if you do it like this, the supports need to be printed on the part itself, so removing them can be a bit tricky.
I designed the tolerances to fit well with my printer at a layer height of 0.2mm.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
