PopUp Cube Box

A fancy speedcube box that will raise the cube when opened.

Settings:
0.2 LH
10% infill
Supports on some parts

Requirements:
4 x Post Screws (3/4 in length x 0.5mm diameter)
Lube
Glue

Refer to the picture to know how it will look like.
Youtube video will be posted soon.


Warning!
--- Precision is important in this build. If your 3D printer does not print accurately, be ready to sand parts.
--- I've tested this several times.
--- Glue and lube (speedcube lube is okay) is required.

Instructions:
1. Glue CaseA to CaseB.
2. Connect the GearCovers to Case using the post screws. Test the movement. Sand or trim if necessary.
3. Print the Slider twice. Then insert to the case and make sure to connect to the GearCover. Test the sliding movement. Sand or trim if necessary.
4. Connect the base to the sliders. Test the movement. Sand or trim if necessary. If satisfied, fix the slider to the base with glue.


See my youtube vid regarding this:
https://you