Thingiverse
Porta SD by overVolt
von overVolt
1
Downloads
3
Likes
0
Makes
*probably a remix from some other design, but it's been many years and I don't really remember where it came from*
Niente supporti, infill non importa (io ho messo 15%).
Pareti almeno spesse 3, meglio se 4.
Meglio se stampato a 0.15 perché viene più precisa la filettatura.
Se stampato in PLA non lasciatelo in macchina al sole sennò si deforma tutta la filettatura :)
Niente supporti, infill non importa (io ho messo 15%).
Pareti almeno spesse 3, meglio se 4.
Meglio se stampato a 0.15 perché viene più precisa la filettatura.
Se stampato in PLA non lasciatelo in macchina al sole sennò si deforma tutta la filettatura :)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!