Slicer Discord
Portable Hanging Crimp – 3D-Druckmodell von Thingiverse Thingiverse

Portable Hanging Crimp

von zephyrok
15 Downloads
10 Likes
1 Makes
Zum Modell
A simple minimalist hanging crimp for training climbing grip strength or warming up at the crag. There are two edges, 20mm and 15mm depth with a 6mm rounded edge. The width of the edge is for a single hand. Super-gluing a strip of sandpaper curved over the top and front each of the crimp edges provides friction. There are two holes for a loop of 7mm or thinner cord.

This has been working well for me to occasionally warm up my fingers at the crag when needed. I usually put my foot in the cord on one side of the crimp while seated and pull against it. Keep in mind, use this at your own risk!

Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen