Portal Security Camera w/ LEDs

I wanted to add red LEDs to the model instead of just printing red lenses. The only parts that are modified from the original version by BleedTheWay are those that are named "PortalCam"

Camera Body - Added channels through the middle of the camera body to put wiring through.

Camera Lens - Hollowed out the inside of the original model to accommodate the LED. I printed the lens with clear PETG. Print it hot, slow, no fan, and thick layers for best results.

Side piece - Added a channel to fit the LED. This was a tight fit and to be honest it's still not perfect but it was good enough.

USB Mount - This part replaces Wall-Arm-Bottom-Piece-Black. I hollowed out the tubes, and cut a chunk out of the back so you can attach a micro-USB port. I recommend printing this part with supports and orienting the tubes to print straight up.


## Electronics and Assembly ##

Parts List

1 - Micro USB Type B Connector - [mouser link](https://www.mouser.com/ProductDetail/GCT/USB3140-30-01