Portapie Zero: Retro

This is a basic model designed for convenient, portable, retro gaming with Retropie or other emulation softwares for Raspberry Pi. To make this, you will need: A soldering iron and solder Wires 1x Raspberry Pi Zero(or Zero W, Zero 2, Zero 2W) 1x Small slide switch 1x Adafruit Powerboost 1000c: https://www.adafruit.com/product/2465 1x Micro SD Card with preferred emulation software written onto it (I personally prefer Retropie) 1x 2000 mAh LiPo Battery: https://www.adafruit.com/product/2011 Solder two wires to the + and - pads on the Powerboost (on the left and right of where you would solder the USB port). Then solder the other side of the two wires as shown in the picture above. Solder the slide switch to the En and GND pins on the side of the Powerboost. This will enable you to turn the Portapie on and off. Plug the battery into the port on the side of the Powerboost. MAKE SURE that the polarity is correct, otherwise it could destroy your Powerboost and possibly even your Raspberry P