Thingiverse

Post Holder with Circular Slotted Base

by Freds_Optix_Hardware

12 Downloads

12 Likes

0 Makes

Slotted base half inch post holder. The holes running up along the body are intended to be tapped for 1/4-20 thumb screws to lock the post in place. The slot in the base is size for clearance to slide along a 1/4-20 screw mounted into a standard 1" x 1" spacing optical breadboard/table. You should use washers when fastening the base to the table to extend the life of the part.

The base can also be secured to the table via a 3" table clamp that is also posted in my collection.

Source

Thingiverse

What you need to print this: Intermediate Low confidence

Single piece Hardware needed

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 1/3

Printer

FDM / FFF

File format