Thingiverse
Post-It Holder
von lhaither
29
Downloads
41
Likes
2
Makes
I need a different size from the original file, so i made edited the stl for these two new sizes.
For whatever reason my post-its wouldn't fit, either larger or "taller".
STLs were repaired by NetFabb
Anyway, I hope you enjoy'em.
No supports =/
Brim, only if needed
Infill, depends on perimeter...
For whatever reason my post-its wouldn't fit, either larger or "taller".
STLs were repaired by NetFabb
Anyway, I hope you enjoy'em.
No supports =/
Brim, only if needed
Infill, depends on perimeter...
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
