Pot and Base - Vase Mode

My wife grows a lot of plants and I have a lot of spools with leftover filament. I came up with this to help us both out. I designed this pot to print in vase mode so that even if the print doesn't complete one still ends up with a pot, except that it's just shorter! The full size pot takes 7 meters or 20gms of filament. The shorter one you see in the photo's was printed with whatever I had left and is of course still usable as a pot. The full size pot measures 110mm in height and about 108mm in diameter at the top.The drainage base takes 2.4 meters or 7gms of filament and can be used when you have just a small amount of filament left. Even if you only manage to get a few millimeters in height printed it could no doubt still be used as intended or keep it as a beverage cover for the fridge.Don't grow plants? Use them as containers for something else - pens, condiments in the fridge, whatever.If you don't want the drainage hole simply remove the subtraction modifier