Pot Planters for Vase Mode

Just some basic pot shapes. Scale to desired size and print in vase mode. Make the print wall thickness about 1mm, or thicker if you think it needs it. (NOTE: Even if you have a 0.4mm nozzle, you can actually print up to about 1.5mm thick in vase mode and still get just fine quality! You should experiment with that! You might be surprised what you can do without changing to a bigger nozzle!)

If you make the 10 inch pot, it's just about equivalent to a 2 gallon pot.

One of them says "Habanero" on the side. You could plant anything you like in it though, the plant won't care.

Tip: cut or poke some holes in the bottom. I usually use an old soldering iron to poke some holes around the bottom, right where the side joins the bottom. Not only does this aid in drainage, but it helps fuse the bottom to the sides a little better where there might be a weak point.