Pot With Lid

Note: Due to bugs, the general instability of Thingiverse, a data leak and numerous bots, spam comments etc. I will no longer upload my files here. The following link will take you to the upload of the model on my Printablesaccount: https://www.printables.com/model/293191-pot-with-lid

Thank you for your understanding!

Three minimalistic pots in three different sizes with lids!
The pots can of course also be used without the lids, I have the edges on which the lid rests purposely kept simple.
The model has no critical overhangs, so everyone should get a wonderful print result.
Please follow the printing instructions below to get the best result.

Print instruction:
I recommend printing the lids with a layer height of 0.2mm. 3 perimeters and 10% infill are sufficient. The slightly angled top of the lid should be printed with a layer height of 0.1 to 0.12mm for a much nicer result. This can be set in the Prusaslicer via "Variable layer height" as shown in the picture. The colo