potentiometer servo controller glove

potentiometer glove to control servo
https://www.youtube.com/watch?v=YNxTY1SYrJU

10k ohm potentiometers where used to control the servos (large ones, part with the fastener is approx 9.5mm in diameter. Turn axle has a diameter of 6mm)
They are controlled with the arduino uno.
I have uploaded the ino and the electric layout.

If your going to start with building this you need to know the output from your potentiometer.
Because you don't have full range of motion.
Use the sketch from arduino tutorial to find the right output.
https://www.arduino.cc/en/Tutorial/AnalogReadSerial

The bracelet is modular and can be adjusted by using the small bracelet plates. So you can make it fit for your hand. The bracelet can be connected to each other using 1.75mm filament. At the end, place the endplate. There a 2 different types, you need both so they can hold the Velcro strips in place.
The distal finger parts are flexible. They need to be so when you flex your fingers they will stay f