Slicer Discord
3DSEARCH / Power Box for Enclosure
Power Box for Enclosure – 3D-Druckmodell von Thingiverse Thingiverse

Power Box for Enclosure

von DigitalEmpire
2 Downloads
2 Likes
0 Makes
Zum Modell
This is the last part of my 3D printer enclosure, designed to contain a custom circuit board to power the Led strip in my enclosure. The board also has an LM2596 board to add a regulated DC output.
You will need an LM2596 board, some 2.54 2pin phoenix connector, a DC jack and two switch.
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
TPU
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Box with Dividers
Box with Dividers
von Agujas3D
↓ 27 ♥ 23
ESP32 GPS Tracking Device | Vehicle Tracking System | Enclosure design
ESP32 GPS Tracking Device | Vehicle Tracking System | Enclosure design
von sketchwork_
↓ 474 ♥ 373
JKTech Enclosure ELECTRONICS V2 - 2023 Update
JKTech Enclosure ELECTRONICS V2 - 2023 Update
von JKSniper
↓ 6
| TIKO | The Raspberry Pi Case w/ Fan
| TIKO | The Raspberry Pi Case w/ Fan
von EvanVS
↓ 78 ♥ 54
Millennium Falcon – One-Piece High Detail 3D Model
Millennium Falcon – One-Piece High Detail 3D Model
von VAIBHAV
↓ 2.5k ♥ 501
Da Vinci Minimaker (XYZprinting) (DRAFT/WIP)
Da Vinci Minimaker (XYZprinting) (DRAFT/WIP)
von TheSamCo
↓ 11 ♥ 5
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
· Impressum · Datenschutz
DE EN FR ES IT NL

Zur Sammlung hinzufügen