Power brick mounting brackets

After moving to my new place I have set up my old Hifi system. For mounting power bars to my Hifi rack I have designed brackets that can be screwed onto the rack and will then hold the power bars firmly in place, using cable ties. I have designed brackets for 2 power bar cross sections which you will find on the 2 print beds in the BambuStudio file, respectively. (1) 72x 40.5mm (2) 65.6x 40.5mm Check what cross section your power bars have. If your power bars have a different size you probably have to scale the models to your needs. My recommendation is to print the brackets 0.5-1mm bigger than your power bar cross section in each direction. The brackets come with 2 holes each for attaching the brackets to a cabinet/rack, the screws can have a max. diameter of 4mm (note: if you scale any of the models the screw holes will also slightly change but this will only be an issue if you change the size dramatically). I am recommending the use of counter sunk screws. Cable ties should have max