Thingiverse
Power Cable Holder
door GR8YT
0
Downloads
0
Likes
0
Makes
This is designed to keep that bundle of cables, heading over to the hot end, under control and out of the way. It is made of two parts;
1. Main Part: This is attached using the existing screw in the extruder. The power cable bundle is routed through the open end at a significant upwards angle to prevent any sag in the wire from becoming an issue.
2. End Cap: This is slip fit and keeps things in their place.
Side Note: With this in place I "released the bowden tube" from that bundle of cables which allowed for a slightly shorter bowden tube.
1. Main Part: This is attached using the existing screw in the extruder. The power cable bundle is routed through the open end at a significant upwards angle to prevent any sag in the wire from becoming an issue.
2. End Cap: This is slip fit and keeps things in their place.
Side Note: With this in place I "released the bowden tube" from that bundle of cables which allowed for a slightly shorter bowden tube.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
