Power Supply Box

I needed for my electronics and audio projects a portable Power Supply.

My focus was not about super portable device. Its simply a housing for a ATX Power Supply which provides many voltage levels.

Printing:
- Infill Body: 20 %
- Infill Top: 20 %
- Support Body: yes
- Support Top: no

You should rotate some file as the "steg" (jetty) for it lays flat on the printing bed.

The *steg* is for secure the powersupply inside. Chose some apropriate screws with a wide head...well, maybe not too wide I guess ;)

*TopHalter* will be printed *4 times* layed flat on its side. Glues this one on the "Deckel".

Körper36 and Körper39 is used for a adjustable PowerSupply in addition. Körper36 is hotglued on the ventilation grille and on it the addtional PowerSupply. On top i hotglued Körper39. So its mostly protected for any short circuit.

I'll add a partlist and where to get it from.
In the holes an its side a wired up some Aviation GX 12 Sockets. But I realised that GX 12 is wa