Thingiverse
Power Supply Box
por TuffyDK
0
Descargas
0
Likes
0
Makes
I have made a Power Supply Box which should fit a 5v / 5A Power Supply from Aliexpress.
The Lid to this box is 0.05 mm bigger than the box, so you need to use a hobby file tool to make it fit on all 4 sides (I like the Lid to be as tight as possible, so that's why it's like that)
Measurements are: 85 x 120 x 43 (85 x 120 x 45 without the Lid attached)
As u have noticed, there is a "notch" on the box back side - Use a small flat screwdriver to pop up the lid if needed.
The Lid to this box is 0.05 mm bigger than the box, so you need to use a hobby file tool to make it fit on all 4 sides (I like the Lid to be as tight as possible, so that's why it's like that)
Measurements are: 85 x 120 x 43 (85 x 120 x 45 without the Lid attached)
As u have noticed, there is a "notch" on the box back side - Use a small flat screwdriver to pop up the lid if needed.
TuffyDK también publica en
2 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
![[REMIX] Modular Power Supply (PSU) Cover for Ender 3](/imgproxy.php?url=https%3A%2F%2Fcdn.thingiverse.com%2Frenders%2Fc4%2F75%2F29%2Ffe%2F4d%2F473dd89f37a76b002a3eae3c78b94c72_display_large.jpg&w=400&h=300)
