Power Supply Case

I had to create my own Power Supply Case for my recently built HyperCube as the other did not seem to fit my needs concerning position of the power cables etc.
There are socket gaps for XT60 connectors, so you can unplug them if you need to.
2 for the Ramps board, one for the HeatBed controller and one spare.

I like the power switch being reachable at the top of the printer

Added lot some pictures of my power supply so you can compare and check if it matches yours.

This one has a voltmeter in the front, more as a power on indicatoin, as the voltage is not supposed to change a lot after it has been set initially. I had some plan to include an amp-meter, which would be much more interesting but I couldn't find one that would have fit into the tight space.