Thingiverse
Power switch cover
by Cowski
3
Downloads
6
Likes
0
Makes
I liked and actually printed the original one but some bad wiring blew the fuse to the one I had and I can't find a fuse to replace it.
So found this switch at Lowes for about $6 and liked the way it looked. I will need to lower the hole ~5mm because the placement of it now is too high & the wiring behind it seems "smashed" up against the other wires which I'm not comfortable with.
Great design & I like the heat slots on it.
Switch: https://www.lowes.com/pd/SERVALITE-Double-Pole-Black-Light-Switch/50107270
Update: v2a is the same as v1 except the switch hold is lowered a little bit. I'll print that out & get pictures of it probably tonight.
Update #2: I just remembered I had to cut a little of the hole out with a knife to get the switch in. I apologize. I just uploaded a v1a and v2a that have cutout holes that are about 2mm bigger which should accommodate the switch correctly.
Update #3: I printed out the new STL file & the switch slid in & snapped very easily. As
So found this switch at Lowes for about $6 and liked the way it looked. I will need to lower the hole ~5mm because the placement of it now is too high & the wiring behind it seems "smashed" up against the other wires which I'm not comfortable with.
Great design & I like the heat slots on it.
Switch: https://www.lowes.com/pd/SERVALITE-Double-Pole-Black-Light-Switch/50107270
Update: v2a is the same as v1 except the switch hold is lowered a little bit. I'll print that out & get pictures of it probably tonight.
Update #2: I just remembered I had to cut a little of the hole out with a knife to get the switch in. I apologize. I just uploaded a v1a and v2a that have cutout holes that are about 2mm bigger which should accommodate the switch correctly.
Update #3: I printed out the new STL file & the switch slid in & snapped very easily. As
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
