Thingiverse
Power switch for 10mm rods
door turfstuf
11
Downloads
10
Likes
0
Makes
This is a box for mounting a Home Depot power switch on the Y axis 10mm rods.
The switch is a Servalite TA201U rocker switch, SPST.
Mounts are borrowed from--
http://www.thingiverse.com/thing:335726
Make sure to solder the wires before snapping the switch into place. The box doesn't open for access inside.
Print with supports or the mounting clips will fail. I used overhang supports generated by Meshmixer.
Note: The photos show the C clips in the wrong position. They have been moved down in the STL file to the other edge of the box so the box doesn't lift the bed up.
The switch is a Servalite TA201U rocker switch, SPST.
Mounts are borrowed from--
http://www.thingiverse.com/thing:335726
Make sure to solder the wires before snapping the switch into place. The box doesn't open for access inside.
Print with supports or the mounting clips will fail. I used overhang supports generated by Meshmixer.
Note: The photos show the C clips in the wrong position. They have been moved down in the STL file to the other edge of the box so the box doesn't lift the bed up.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
