Power switch front mount for Ender3v2

A small mount plate to move the power switch of the Ender3v2 to the front right, next to the control panel. Re-uses the original switch, only ~50cm two-core cable is needed, plus 4 connectors.
Cable is routed along the display cable, then through the lower furrow of the 4040 beam (this is why the thing is erased box-style, so the cable can easily pass in). The core opening of the 4040 rail is exactly right size for the switch :)

A more concise description has been requested - I'll try my best.
+ disconnect the power cord
+ open the cover of the power supply (from the bottom side)
+ disconnect the two plugs from the power switch
+ crimp two male plugs (left in 4th image) on a two-cord cable safe for mains power
+ connect those to the two female plugs you just disconnected from the PS
+ route the cable towards the main board, from there along the display flat cable
+ when at the right 4040 beam, route the cable through the closer of the furrows towards the front
+ remove th