PowerA Xbox Controller Right Trigger Mechanism

This Is the part that breaks off easiest in the PowerA Xbox1/PC controllers.
This Printed at .2 100% with tree supports touching build plate.

It works.
My trigger wasn't working at all and now it can fire again.

Unfortunately it didn't fix my issue where it was stuck in "Hair Trigger" mode
I didn't see how to fix that by looking at the internals of the controller.

To replace , loosen all screws on back face.
back face can lift straight up
(can keep screws in it)

In the well of the right trigger there is a part that is held in with 2 screws you may remove this. (its likely broken in half if you were looking up this .stl )

just print this up (takes like 14min )
and screw in place using the screws in the controller [obv]
loop the peg thru the hoop in the trigger lever arm.

close it back up.