Thingiverse
PPS43 magazine adapter
door jestertoo
0
Downloads
2
Likes
0
Makes
Clamshell adapter to put PPS mags into a different magwell of a very popular and common lower.
Uses M3x19 (I just grind a bit off 20mm) threaded screws to hold it together. Do not overtighten, it's not needed.
v9 added pockets for M3 nuts.
Depending on what magazine/upper/boltcarrier/etc, you have to pick the height of the magazine in the adapter.
Filename Zplus0mm is the base height, z+0p5 9s 0.5mm, z+1mm and z+2mm raise the PPS magazine up inside the adapter by 1 and 2mm respectively. You want the PPS magazine to be just below the point where it's dragging on the bolt carrier.
created v10, left and right halves, of the v9 +0.5mm model. Bambu studio was trying to join the halves back together when slicing.
Uses M3x19 (I just grind a bit off 20mm) threaded screws to hold it together. Do not overtighten, it's not needed.
v9 added pockets for M3 nuts.
Depending on what magazine/upper/boltcarrier/etc, you have to pick the height of the magazine in the adapter.
Filename Zplus0mm is the base height, z+0p5 9s 0.5mm, z+1mm and z+2mm raise the PPS magazine up inside the adapter by 1 and 2mm respectively. You want the PPS magazine to be just below the point where it's dragging on the bolt carrier.
created v10, left and right halves, of the v9 +0.5mm model. Bambu studio was trying to join the halves back together when slicing.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!