Predator 212 Engine mount plate

WIP: This plate is designed to replace the nylon washer solution people have been using to mount the predator 212cc engine to Mclane reel mowers. This is designed to raise the engine .500 in off of the mower deck.

I have included the project file so that you can have the blocks already in place on the printer. You will need to change it to match your printer specifically.

Updated 05/24:
Some different models have the hole offsets different. I updated the v1.2 to have the holes at 6.69in to the outside of each hole.

Update: 11/11/2023:
Pla+ could not withstand heat and subsequently melted, very slowly. I have reprinted the item in ABS and even with just initial install I can feel the difference.
PLA+ has a normal-ish glass transition point at 60c where as ABS is 105c. So should last significantly longer and withstand engine temps much better