Thingiverse
Pressure advance test print
von teikjoon
11
Downloads
4
Likes
0
Makes
Test print for pressure advance (klipper firmware), but would probably be useful for Marlin's Linear Advance as well.
I add the command :
SET_PRESSURE_ADVANCE ADVANCE=0.100
At every 25 layers (5mm) and increse this value by 0.1, which gives me a range of 0.0 to 1.9
You can also scale the print down to test single pressure advance values.
Best printed with brim, because its very thin and you're not really testing bed adhesion with this print.
I add the command :
SET_PRESSURE_ADVANCE ADVANCE=0.100
At every 25 layers (5mm) and increse this value by 0.1, which gives me a range of 0.0 to 1.9
You can also scale the print down to test single pressure advance values.
Best printed with brim, because its very thin and you're not really testing bed adhesion with this print.
teikjoon veröffentlicht auch auf
3 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
